allonmorris
About
Shark Nv360 Losing Suction Power: Causes And How To Fix
Vacuum cleaners have become an extremely familiar item for every household. Especially, Shark NV360 vacuum has been receiving more and more support from customers.
However, after a period of use, you will often find your vacuum cleaner encounters problems and suction power. Sometimes when you encounter this problem, you immediately think of giving up the old machine and buying a new one. So, let's find the cause and fix the vacuum cleaner when it loses suction in the article below!
Wrong altitude setting
The first fundamental cause of a shark 360 vacuum not working as it should is because you have set the machine height too high for the type of floor you are vacuuming.
Usually, there will be steps or buttons to raise or lower for you to adjust accordingly on the vacuum cleaner.
Some symbols you often see appear as Bare Floor or Hard Floor, then are numbered corresponding to the levels.
In fact, the Bare Floor is usually the lowest level your vacuum can move and is easily applied to any property. The reason is that in this operating mode, the vacuum cleaner will stick to the floor to create the most potent suction.
Therefore, if your vacuum cleaner has less suction power than before, lower the height setting of the machine to the lowest level!
The dust bag is full
The second cause is that your dust cup is full.
In this case, you can do it very quickly. You open and check your cup or dust bag to check if it is full or dust in the cup or replace a new filter bag.
Connector is clogged
If you have done both the above but your machine is still not working correctly, try to see if the cause is the connection pipe or not.
Remove the dust bag or container and look at the hole in the hose where it connects to the machine. It is to see if there's anything stuck inside, like hair or some metal.
If so, take them out and check if the machine is working correctly or not.
Vacuum cleaner not airtight
In addition to the above causes, you can see if the vacuum cleaner is not airtight. Vacuum cleaners work on the principle of vacuum combined with suction to suck dirt out of the floor.
If too much air gets out of the system, they can't use suction and pull dirt into the calves.
You need to check the part of the hose that speaks to the vacuum cleaner to make sure the machine is not letting out too much air.
Besides, you also need to make sure that the parts are installed in the correct position and match each other after checking.
Dust brush is stuck
The last possible cause is the dusting brush in the machine. If the broom gets caught in the grain or carpet fibers, it is understandable that it cannot function properly.
You need to check the brush part of the machine to see if objects like hair or carpet fibers are stuck. If so, clean them thoroughly.
Thus, today's article has sent you to Shark navigator NV360 reviews about the causes and how to fix it when the machine loses suction power. Hopefully, with the above information, you can use the vacuum cleaner more easily.
Read More:
How do i know if my roomba is charging